|October 9, 2012, 16:11||
Where To Begin
Join Date: Sep 2012
Location: Azusa, Ca
Posts: 11Rep Power: 4
I am fairly new to openFoam and had a general question. I'm not sure if this is the right forum, but I figured it was as good as any.
I have gone through the tutuorials in the user's guide, but would like to start my own simulation. However, I am not sure how to actually start a fresh model. Would I have to copy the files (0, System, and Constant) from another file? If not, is there a standard template to begin from?
Thank you in advance for any help you can provide.
|October 10, 2012, 03:09||
Join Date: May 2009
Location: Delft, Netherlands
Posts: 919Rep Power: 17
I would indeed just copy it from a case that is similar to your desired setup.
*On twitter @akidTwit
*Spend as much time formulating your questions as you expect people to spend on their answer.
*Help define the OpenFOAM stackexchange Q&A site: http://area51.stackexchange.com/prop...oam-technology
|Thread||Thread Starter||Forum||Replies||Last Post|
|Sensible parameters to begin with||haconk||CFX||7||July 18, 2014 03:21|
|help! where to begin study OF?!||houkensjtu||OpenFOAM||6||September 13, 2012 00:57|
|when the angle of attack =?, the total lift coefficient begin to decrease suddenly||liujmljm||Main CFD Forum||6||August 3, 2012 05:46|
|How to begin CFD?||gtarang||Main CFD Forum||3||February 16, 2011 09:49|
|i begin use udf please help||tana||FLUENT||2||April 20, 2004 05:48|