|June 16, 2015, 10:57||
Adding LTSInterfoam to foam-extend 3.1
To start off, i would like to let you know I have OpenFOAM 2.3.1 and foam-extend 3.1 in my computer. I installed foam-extend because i wanted to use swak4foam and had difficulties installing it in OpenFOAM 2.3.1.
Now i want to do some simulation using LTSInterFoam in foam-extend 3.1 but is not there.I can run it of2.3.1 but i want to use swak4foam to do some calculations so thats why I would like to know how add it to foam-extend 3.1 . I tried copying it from of2.3.1 and then compiling it but this led to some erros show in the image below.
I hope someone can help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|error message with modeling a cube with a hold at the center||hsingtzu||OpenFOAM Native Meshers: blockMesh||2||March 14, 2012 10:56|
|mesh airfoil NACA0012||anand_30||OpenFOAM Meshing & Mesh Conversion||12||December 12, 2011 05:16|
|BlockMesh FOAM warning||gaottino||OpenFOAM Native Meshers: blockMesh||7||July 19, 2010 14:11|
|Axisymmetrical mesh||Rasmus Gjesing (Gjesing)||OpenFOAM Native Meshers: blockMesh||10||April 2, 2007 14:00|
|Import gmsh msh to Foam||adorean||Open Source Meshers: Gmsh, Netgen, CGNS, ...||24||April 27, 2005 08:19|