|May 4, 2016, 00:33||
Iterative boundary condition
Join Date: Mar 2016
Posts: 30Rep Power: 2
I have gone through all your suggestions about egassing BC I am trying to built BC based on Evaporation.
I am writting an interface condition for inlet where liquid converts to gas Method is very simple
1. first i have assume inlet temp 10k below boiling temp say Ts=290 and Tb=300
2.Then calculation XFs=exp((-hfg*Mw/Ru)((1/Ts)-(1/Tb)) Basic Clausious Claeperon hfg latent heat , Ru gas constant, Mw molecular weight of liquid.
3.Using Xfs we can find Yfs=(Xfs*Mw)/Mw,mix , Mw,mix is molecular weight of liquid
4.By using Yfs we can calculate velocity Us=diff*(gradYf)/(1-Yf).
5.We check that our assumed Ts value is right or not using gradTs = rho*Us*hfg/k.
If assumed Ts is write, Ts will be the boundary condition temp of inlet else it will go to re-iterate. until Ts=0.98Tb.
I can also send you code of c++ i tried and code of codestram can you plz help regarding this. Can we use for loop in groovy BC???
please send your valuable suggestions
|Thread||Thread Starter||Forum||Replies||Last Post|
|Centrifugal fan||j0hnny||CFX||12||January 7, 2016 03:44|
|sliding mesh problem in CFX||Saima||CFX||45||September 22, 2015 10:53|
|Accessing multiple boundary patches from a custom boundary condition file||ripudaman||OpenFOAM Programming & Development||0||October 22, 2014 18:34|
|Radiation interface||hinca||CFX||15||January 26, 2014 18:11|
|An error has occurred in cfx5solve:||volo87||CFX||5||June 14, 2013 17:44|