|August 29, 2009, 16:27||
How to add new Boundary types
Join Date: Jun 2009
Location: Colorado, USA
Posts: 112Rep Power: 9
I believe that 2 new boundary types are needed for realistic simulations of wind turbines (or any wings), because movingWallVelocity causes too much drag on wings.
I'd like to add 2 new types. movingWallSlip, and movingWallPartialSlip.
My questions are: 1) Is anyone currently doing this or know a way to already do this? 2) Could someone point me to the files / classes that I need to look at to figure out how partialSlip and slip are implemented and where I would attempt to add the movingWall versions?
|movingwall, partialslip, slip|
|Thread||Thread Starter||Forum||Replies||Last Post|
|inlet velocity boundary condition||murali||CFX||5||August 3, 2012 08:56|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Boundary zone types?||Amr||FLUENT||2||February 23, 2006 07:35|
|Boundary conditions?||Tom||Main CFD Forum||0||November 5, 2002 02:54|
|Boundary Conditions||Jan Ramboer||Main CFD Forum||11||August 16, 1999 08:59|