|
[Sponsors] |
Is neighbourFieldName used for solids in chtMultiRegionFoam? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 16, 2010, 08:26 |
Is neighbourFieldName used for solids in chtMultiRegionFoam?
|
#1 |
New Member
Niklas Järvstråt
Join Date: Mar 2010
Posts: 4
Rep Power: 16 |
Hi!
When I set a bad name in a fluid changeDictionary, I get an error message of the type: --> FOAM FATAL ERROR: request for volScalarField Thisiswrong from objectRegistry wire failed available objects of type volScalarField are 7 ( cp K rho sigma T rhosCps Vel ) Which is fine, of course. However, doing the same in a solid region gives no error message whatsoever and the calculation proceeds as if nothing is wrong. Is this because the neighbor name of solids is hardcoded somehow, or what happens here? (I need to know because I try to adapt solidWallMixedTemperatureCoupled for use not with temperature but with voltage) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with running chtMultiRegionFoam after using setSet utility | Victor | OpenFOAM | 12 | March 24, 2023 00:01 |
How can I do a solidWallMixedVoltageCoupled patch in chtMultiRegionFoam? | Niklas Järvstråt | OpenFOAM Programming & Development | 2 | April 1, 2010 05:22 |
chtMultiregionFoam | msarkar | OpenFOAM | 21 | February 10, 2010 23:12 |
chtMultiRegionFOAM " Heattransfert" | ronaldo | OpenFOAM | 1 | January 1, 2010 10:08 |
problems with probes() function in chtMultiRegionFoam | Victor | OpenFOAM | 0 | November 25, 2009 15:08 |