 |
 |
 |
|
|
|
[Sponsors] | ||||
March 29, 2012, 21:37
|
Change boundary patch type within LES model
|
#1 |
|
New Member
Ben Colcord
Join Date: Mar 2012
Location: Atlanta
Posts: 2
Rep Power: 0  |
Hello,
I'm trying to implement an LES model that solves 1D equations for the small-scale velocity within each cell. I use only one subgrid mesh to solve the subgrid equations on each cell sequentially. This is required to save on storage. For internal cells the boundary conditions are always cyclic, but I want to be able to change the patch type if the cell is on the boundary. So far, I can't figure out how. Any suggestions? Thanks |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent msh and cyclic boundary | cfdengineering | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 48 | January 25, 2013 03:28 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Cyclic BC's: Possible face ordering problem? (Channel flow) | sega | OpenFOAM Native Meshers: blockMesh | 3 | September 28, 2010 12:46 |
| CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 21:25 |
| Please help with flow around car modelling! | Tudor Miron | CFX | 17 | March 19, 2004 19:23 |
Linear Mode
