|
[Sponsors] |
August 2, 2012, 07:48 |
Edge grading for polyline
|
#1 |
New Member
Join Date: Aug 2012
Posts: 2
Rep Power: 0 |
Hi,I want to know how the process is done for plotting the points on the polyline if the edge grading is known.I am trying to make a structured CGNS file creator but i am stuck at a point where i have to implement the edge grading on the polylines.I know the raw polyline data.How do i use it with the edge grading to make the proper curve of proper point distributions.An explaination would be helpful.Thank you.If my question was vague please tell me .
|
|
August 7, 2012, 04:23 |
|
#2 |
Senior Member
|
Hi,
do you know that there are some CGNS capabilaties for OF http://openfoamwiki.net/index.php/Si...GNS_Converters |
|
August 7, 2012, 06:47 |
|
#3 |
New Member
Join Date: Aug 2012
Posts: 2
Rep Power: 0 |
Hi,I know that it has a cgns converter..but it converts to unstructured grid...I need a structured grid.So if anyone could explain a bit how the algorithm works...it would have been helpful.I need to integrade the edge grading into polylines.So i wanted to know how if possible.??
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[Commercial meshers] Star mesh import problem | chris1980 | OpenFOAM Meshing & Mesh Conversion | 20 | May 8, 2006 01:07 |