 |
 |
 |
|
|
|
[Sponsors] | ||||
May 2, 2012, 05:17
|
MRFSimpleFoam setup
|
#1 |
|
Senior Member
sivakumar selvaraju
Join Date: Mar 2009
Location: India
Posts: 205
Rep Power: 18   |
Hello Guys,
I have a simple question, I have tried the case in simpleFoam, it is working fine Now I am trying to run the same case in MRFSimpleFoam, for this, 1) What are the corrections I need to do, in my files. 2) I have copied my simpleFoam polyMesh folder in to MRFSimpleFoam/ fanTest folder 3) the I have executed blockMesh, while comparing the polyMesh folder with mixerVessle2D, cellZone file is missing. what should I do? give me your suggestions please with regards, Sivakumar |
|
|
|
|
|
May 2, 2012, 14:35
|
|
#2 |
|
Senior Member
lore
Join Date: Mar 2010
Location: Italy
Posts: 460
Rep Power: 18 |
||
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
| MRFSimpleFoam Tutorial | bastil | OpenFOAM Running, Solving & CFD | 48 | August 1, 2012 10:00 |
| about MRFSimpleFoam and ggi | wllmk1 | OpenFOAM Running, Solving & CFD | 0 | February 5, 2011 04:52 |
| Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2009 21:58 |
| setup vof test problem | Fang Jin | FLUENT | 1 | June 14, 2005 08:27 |
Linear Mode
