|May 7, 2012, 10:46||
compressible flow in a channel
Join Date: Apr 2012
Posts: 1Rep Power: 0
i like to simulate a compressible flow through a channel. I suggest rhoCentralFoam is a good choice in my case, because its a laminar flow with a small velocity. I've started to modify the shocktube-case, but still get error messages if the internal pressure is smaller as the inlet- or outlet pressure.
I've experience in incompressible flow with icoFoam and wondering about the conversion to the compressible case.
1. How do I set the pressure at inlet, outlet and internal fields?
2. How do I set the velocity in this fields?
3. Is the heat-exchange only defined in the T - file?
Thanks a lot,
|Thread||Thread Starter||Forum||Replies||Last Post|
|Yacht in Open Channel Flow||andreimour||FLUENT||1||October 15, 2010 00:54|
|Complex problem: Open Channel Flow||lett||FLUENT||17||April 9, 2009 11:56|
|supersonic channel flow||Ingo Meisel||Main CFD Forum||15||August 26, 2005 08:00|
|Channel Flow reference||Jonas Holdeman||Main CFD Forum||0||September 10, 2003 16:49|
|compressible channel flow||sky||Main CFD Forum||0||December 5, 2002 10:05|