CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Running, Solving & CFD (http://www.cfd-online.com/Forums/openfoam-solving/)
-   -   Picking boundary conditions for a mixing chamber (http://www.cfd-online.com/Forums/openfoam-solving/104175-picking-boundary-conditions-mixing-chamber.html)

buffi July 4, 2012 05:49

Picking boundary conditions for a mixing chamber
 
Hi,

I want to model a mixing chamber with two inlets and two outlets. I created the mesh with blockMesh and it looks fine, however I am unable to come up with sensible boundary conditions.

I could use cyclic boundary conditions for each pair of inlet/outlet, but in that case it's not possible to have a redistribution of mass flows between each pair (m_in1 = m_out1, m_in2 = m_out2).

I don't want to use direct mapped patches because I cannot assume a fully developed flow at the "ports". However, the benefit of direct mapped patches is that I can prescribe the distribution of mass flows.

Can you suggest me suitable boundary conditions to look into?

Regards

buffi


All times are GMT -4. The time now is 01:31.