 |
 |
 |
|
|
|
[Sponsors] | ||||
July 12, 2012, 07:28
|
Boundary condition
|
#1 |
|
New Member
Join Date: Mar 2012
Posts: 5
Rep Power: 14  |
Hi
There seems to be a problem in my axisymmetric jet case. The wedge boundary condition does not seem to be satisfied. The above mentioned problem happens only in openfoam 210 and 211. It seems to work fine in 201. I have attached my case directory. Just run blockMesh and then run simpleFoam. Just run it for a few iterations. Then use patchIntegrate phi front or back to find out the mass flux. It should be zero, but its not. Can anybody please check and tell me why it happens. Tell me even its working perfectly for you Last edited by comedy_tigers88; July 13, 2012 at 04:30. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
| Boundary Conditions | Thomas P. Abraham | Main CFD Forum | 20 | July 7, 2013 05:05 |
| Setting outlet Pressure boundary condition using CAFFA code | Mukund Pondkule | Main CFD Forum | 0 | March 16, 2011 03:23 |
| How exactly the "pressure outlet" bdry condition compute properties on the boundary? | yating9901 | FLUENT | 3 | June 28, 2010 12:26 |
| How to set boundary condition in Fluent for the fo | Peiyong | FLUENT | 1 | November 10, 2006 11:44 |
Linear Mode
