[aerospain]

Dear all,

I am running into divergence when using a mesh exported from GridPro to OpenFOAM. I have been trying all the suggestions I have found in this forum for this problem.

I am attaching a zip with my problem, in case someone can share a few minutes to help me out.

I have deleted all files from 'constant/polymesh' but 'boundary' due to the huge size of the other files, i.e. "faces, points, ..."

There could be two possibilities:
1- something bad happened when exporting the mesh from GridPro (out of the scope of this thread, but anyone welcome to share ideas )
2- or, I have messed around too much with the configuration files when adapting them from another case.

I am also attaching two screen-captures to show a general view of my domain: inlet at Xmin, outlet at Xmax, top/bottom/left/right are symmetry, and the sphere is a no-slip wall.

Thanks!
Carlos