Wind profile boundary layer problem

rafamusura · October 4, 2012, 11:49

Hi everyone I'm simulationg a 3D delta wing in atmospheric conditions. I'm using the simpleFoam-motorBike configuration and everything seems to be ok, but the only problem I have is that the boundary layer formed over the ground isn't constant. It seems to me that when the patch of "inlet" start blowing it generates a boundary separation and that makes the wind profile not to be constant as I need.

Do anyone knows how to implement an inlet wind profile boundary condition?, I've tried swak4Foam to implement the groovy BC but I fail trying to make it work.

Please help me, I'm quite desperate here.

Thanks

Eloise · October 5, 2012, 10:42

Hi Rafael,

Are you aware of the wall function problems when simulating ABL flows? Blocken described it in some papers such as this one
http://www.sciencedirect.com/science...5223100600834X
If you don't adapt your mesh and wall function parameters to ABL flow, you will have large variations of your profile through your domain.

I hope this already helps a bit. I've never used swak4Foam but I'm planning to test it soon. Let me know if you manage to get it to work!
Regards,
Eloïse

October 4, 2012, 11:49	Wind profile boundary layer problem	#1
rafamusura New Member Rafael Valenzuela Musura Join Date: Feb 2012 Posts: 27 Rep Power: 14	Hi everyone I'm simulationg a 3D delta wing in atmospheric conditions. I'm using the simpleFoam-motorBike configuration and everything seems to be ok, but the only problem I have is that the boundary layer formed over the ground isn't constant. It seems to me that when the patch of "inlet" start blowing it generates a boundary separation and that makes the wind profile not to be constant as I need. Do anyone knows how to implement an inlet wind profile boundary condition?, I've tried swak4Foam to implement the groovy BC but I fail trying to make it work. Please help me, I'm quite desperate here. Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GAMBIT meshing problem for boundary layer	Falah	FLUENT	2	November 30, 2020 14:16
Questions about Boundary Layer Thickness and Turbulence Models	famerfamer	STAR-CCM+	3	July 12, 2012 09:47
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6	prashanthreddyh	ANSYS Meshing & Geometry	1	December 20, 2011 00:35
[snappyHexMesh] Problem with the boundary layer using snappyHexMesh	LVDH	OpenFOAM Meshing & Mesh Conversion	13	March 15, 2010 10:42
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05

October 5, 2012, 10:42		#2
Eloise Senior Member Eloïse Join Date: Jul 2012 Location: Trondheim, Norway Posts: 113 Rep Power: 13	Hi Rafael, Are you aware of the wall function problems when simulating ABL flows? Blocken described it in some papers such as this one http://www.sciencedirect.com/science...5223100600834X If you don't adapt your mesh and wall function parameters to ABL flow, you will have large variations of your profile through your domain. I hope this already helps a bit. I've never used swak4Foam but I'm planning to test it soon. Let me know if you manage to get it to work! Regards, Eloïse