 |
 |
 |
|
|
|
[Sponsors] | ||||
November 13, 2012, 08:55
|
nonNewtonianIcoFoam
|
#1 |
|
New Member
Emil Baric
Join Date: May 2012
Location: Graz. Austria
Posts: 12
Rep Power: 3  |
Hello everybody,
I would kindly ask you if you could help me. I have a relatively simple 2D axysymetrc case to solve- a linearly converging gap with the lower wall moving at the constant velocity. But i seem to run into trouble with the pressure equation from the very beginning with the number of iterations going to 1001. And I am quite sure that it is not a mesh (discretization) problem. any advice? Thank you Emil |
|
|
|
|
|
November 16, 2012, 05:33
|
|
#2 |
|
New Member
Emil Baric
Join Date: May 2012
Location: Graz. Austria
Posts: 12
Rep Power: 3 |
But it was the boundary condition problem
|
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Couette flow with nonNewtonianicoFoam | floooo | OpenFOAM Running, Solving & CFD | 2 | December 7, 2010 05:39 |
| nonNewtonianIcoFoam wmake | T.D. | OpenFOAM Running, Solving & CFD | 1 | November 4, 2010 12:36 |
| problem with nonNewtonianIcoFoam | mhassani | OpenFOAM Running, Solving & CFD | 1 | July 17, 2010 04:49 |
| nonNewtonianIcoFoam - problem with parallel run | chris_sev | OpenFOAM Bugs | 4 | April 1, 2009 09:13 |
| NonNewtonianIcoFoam for steadystate problem | mpml | OpenFOAM Running, Solving & CFD | 7 | July 20, 2005 19:09 |
Linear Mode
