Using steady state simulation as initial condition in another solver

TommyJ · June 3, 2022, 19:49

Hi OpenFoam community,

I just started using the software and have a newbish question.

I have done a simulation with simpleFoam to get a steady state condition.

Now I want to use this steadystate condition (velocity and pressure) in another simulation as the initial condition. The mesh is exactly the same. Can I just copy the results from the latest time step into the 0/ directory and erase the location and arch from the header in FoamFile?

Is copy/paste enough? Is there a utility to do this? What is the procedure?

dlahaye · June 5, 2022, 15:13

Edit system/controlDict and set startTime for simulation-2 equal to endTime of simulation-1.

TommyJ · June 6, 2022, 03:37

Quote:

Originally Posted by dlahaye

Edit system/controlDict and set startTime for simulation-2 equal to endTime of simulation-1.

Hi thank you for the reply.
What if the second solver is transient?
To your knowledge is there a problem with copying the files into the zero folder to use as initial condition?

Best regards,

dlahaye · June 7, 2022, 09:19

Both approaches work.

June 3, 2022, 19:49	Using steady state simulation as initial condition in another solver	#1
TommyJ New Member Join Date: Jun 2022 Posts: 19 Rep Power: 3	Hi OpenFoam community, I just started using the software and have a newbish question. I have done a simulation with simpleFoam to get a steady state condition. Now I want to use this steadystate condition (velocity and pressure) in another simulation as the initial condition. The mesh is exactly the same. Can I just copy the results from the latest time step into the 0/ directory and erase the location and arch from the header in FoamFile? Is copy/paste enough? Is there a utility to do this? What is the procedure?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Suppress twoPhaseEulerFoam energy	AlmostSurelyRob	OpenFOAM Running, Solving & CFD	33	September 25, 2018 17:45
Segmentation fault when using reactingFOAM for Fluids	Tommy Floessner	OpenFOAM Running, Solving & CFD	4	April 22, 2018 12:30
simpleFoam error - "Floating point exception"	mbcx4jc2	OpenFOAM Running, Solving & CFD	12	August 4, 2015 02:20
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
Orifice Plate with a fully developed flow - Problems with convergence	jonmec	OpenFOAM Running, Solving & CFD	3	July 28, 2011 05:24

June 5, 2022, 15:13		#2
dlahaye Senior Member Domenico Lahaye Join Date: Dec 2013 Posts: 723 Blog Entries: 1 Rep Power: 17	Edit system/controlDict and set startTime for simulation-2 equal to endTime of simulation-1.

June 7, 2022, 09:19		#4
dlahaye Senior Member Domenico Lahaye Join Date: Dec 2013 Posts: 723 Blog Entries: 1 Rep Power: 17	Both approaches work.