|December 3, 2012, 05:44||
Closed Volume: Mass increases, pressure and temperature decrease...
Join Date: Aug 2012
Posts: 74Rep Power: 5
I'm running a case with a room without outlets which is filled with air at 20°C and an ammonia mass flow of 0.1 g/s INTO the room. The inlet gas temperature is set to 20°C, too.
I would have expected an increase in pressure and temperature, as the mass in the system increases. But now I'm observing an opposite behaviour: after 450 seconds, the average temperature has decreased by more than 10K!
I'm using sprayFoam, the thermo-model is hsPsiMixtureThermo, radiation/reactions/combustion are all set to "off". I'm afraid sprayFoam or my thermo model can't handle the mixture. I've heard about excess enthalpy for real gas mixtures, but I can't believe that mixing 45g of ammonia with 38 kg of air decreases the temperature by more than 10K !?
Has anyone ever encountered this phenomenon and is able to tell me, how to fix it?
Thank you very much!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Calculation of the Governing Equations||Mihail||CFX||7||September 7, 2014 06:27|
|Radiation interface||hinca||CFX||15||January 26, 2014 18:11|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|Simulation of a single bubble with a VOF-method||Suzzn||CFX||18||October 2, 2009 04:18|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|