starting compressible flow from incompressible flow results

mihaipruna · November 30, 2012, 13:14

Since my compressible solution always blows up (internal flow, subsonic, rhoSimplecFoam), and I am able to get some results running an incompressible solver (simpleFoam) , is there a way to start your solution for the compressible solver based on the pressure and velocity obtained after a certain number of iterations with the incompressible solver?

Lieven · November 30, 2012, 16:56

If the mesh and boundary conditions are exactly the same, you can simply copy the U and p from he simpleFoam simulation to the 0-folder of the compressible case.

If the mesh is not the same, you can have a look at mapFields (http://www.openfoam.org/docs/user/mapFields.php ).

Regards,

L

mihaipruna · December 3, 2012, 10:02

hi Lieven
Thanks for the response. For the incompressible solver, the pressure is normalized by rho. For the incompressible solver, you set the pressure in its real units.
Any way to get around this when reusing that field?

November 30, 2012, 13:14	starting compressible flow from incompressible flow results	#1
mihaipruna Senior Member Mihai Pruna Join Date: Apr 2010 Location: Boston Posts: 195 Rep Power: 16	Since my compressible solution always blows up (internal flow, subsonic, rhoSimplecFoam), and I am able to get some results running an incompressible solver (simpleFoam) , is there a way to start your solution for the compressible solver based on the pressure and velocity obtained after a certain number of iterations with the incompressible solver?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Compressible de Laval Nozzle Flow	rw511	CFX	3	May 22, 2011 19:48
Incompressible, Unsteady Cylinder Flow	startingcfd	Main CFD Forum	1	March 15, 2011 01:12
Natural Convection using Compressible Flow (chtMultiRegionFOAM)	msarkar	OpenFOAM	2	September 7, 2010 00:13
flow simulation across a small fan	jane luo	Main CFD Forum	15	April 12, 2004 17:49
momentum under-relaxation for compressible flow with SIMPLE	Mihai ARGHIR	Main CFD Forum	0	April 7, 2000 04:58

November 30, 2012, 16:56		#2
Lieven Senior Member Lieven Join Date: Dec 2011 Location: Leuven, Belgium Posts: 299 Rep Power: 22	If the mesh and boundary conditions are exactly the same, you can simply copy the U and p from he simpleFoam simulation to the 0-folder of the compressible case. If the mesh is not the same, you can have a look at mapFields (http://www.openfoam.org/docs/user/mapFields.php ). Regards, L

December 3, 2012, 10:02		#3
mihaipruna Senior Member Mihai Pruna Join Date: Apr 2010 Location: Boston Posts: 195 Rep Power: 16	hi Lieven Thanks for the response. For the incompressible solver, the pressure is normalized by rho. For the incompressible solver, you set the pressure in its real units. Any way to get around this when reusing that field?