|December 24, 2012, 11:35||
Solving 2D Heat Transfer Problem
Join Date: Dec 2012
Posts: 1Rep Power: 0
I am new to openFoam and have some flow problems. Now I would like to solve 2D heat transfer problem with two different solid materials (no flow just conduction). Therefore I have chosen the scalarTransportFoam solver, which solves dT/dt + grad(U*T) + laplace(DT*T) = 0 . Due to the fact that I consider solid materials my U-field is set to zero in the boundary and initial conditions.
I would like to know how I can vary my diffusion coefficient/ heat conductivity DT in the field?
Therefore I have created a mesh with gmsh that consists of two sets. When running gmshToFoam in the folder constant/polyMesh/sets two files "Pipe" and "Filling" are created.
How can specify the value of DT for the two sets in the transportProperties file?
Or am I on the path for such a problem?
Kind regards and merry Chrismas!
|December 30, 2012, 08:19||
Join Date: May 2009
Location: Delft, Netherlands
Posts: 1,141Rep Power: 20
*On twitter @akidTwit
*Spend as much time formulating your questions as you expect people to spend on their answer.
*Join the OpenFOAM stackexchange Q&A site: http://area51.stackexchange.com/prop...oHPxcPqde7HtA2
|Thread||Thread Starter||Forum||Replies||Last Post|
|Interfoam blows on parallel run||danvica||OpenFOAM Running, Solving & CFD||16||December 22, 2012 03:09|
|Low Mach number Compressible jet flow using LES||ankgupta8um||OpenFOAM Running, Solving & CFD||7||January 15, 2011 14:38|
|Problems with simulating TurbFOAM||barath.ezhilan||OpenFOAM||13||July 16, 2009 05:55|
|Computational time||sunnysun||OpenFOAM Running, Solving & CFD||5||March 16, 2009 04:32|
|Differences between serial and parallel runs||carsten||OpenFOAM Bugs||11||September 12, 2008 11:16|