 |
 |
 |
|
|
|
[Sponsors] | ||||
April 10, 2013, 04:09
|
Moving heat source
|
#1 |
|
Senior Member
Mohammad Shakil Ahmmed
Join Date: Oct 2012
Location: AUS
Posts: 137
Rep Power: 14  |
Hi guys,
I want to simulate the following equation: $ \frac{dT}{dt} -v \frac{dT}{dx}= \frac{k}{\rho Cp} \nabla^{2} T +S $ Now I am little bit confused about v, i.e velocity. In OpenFOAM, whether I have to set up as boundary condition or internal field ? Thanks in advance. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GPU Linear Solvers for OpenFOAM | gocarts | OpenFOAM Announcements from Other Sources | 37 | August 17, 2022 14:22 |
| laser moving heat source simulation in ansys | rajat27feb | ANSYS | 0 | September 6, 2012 06:41 |
| [ANSYS Meshing] Laser moving heat source simulation in ansys | rajat27feb | ANSYS Meshing & Geometry | 0 | September 6, 2012 02:41 |
| how to load the heat source to wall | david yang | Main CFD Forum | 1 | October 12, 2009 13:34 |
| UDFs for Scalar Eqn - Fluid/Solid HT | Greg Perkins | FLUENT | 0 | October 13, 2000 23:03 |
Linear Mode
