|April 10, 2013, 03:26||
Problem with transient simulation of pump inner flow by pimpleDyMFoam on 1.6-ext
Join Date: Jun 2009
Posts: 75Rep Power: 8
I have a problem regarding running of a pump case with pimpleDyMFoam on OpenFOAM-1.6-ext.
After I have set my case, and using the "pimpleDyMFoam" command with single core on my computer, and the computation was quickly stopping with the following information:
and the constant/dynamicMeshDict, system/fvSolution, system/fvSchemes, and system/controlDict are attached!
Thank you for any help!
Last edited by renyun0511; April 20, 2013 at 04:11.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Solidworks Flow Simulation, Problem with Point Goals||TomSteventon||FloEFD, FloWorks & FloTHERM||2||February 8, 2012 12:02|
|mass balance problem in transient simulation||nana84||CFX||2||April 15, 2010 19:53|
|transient compressible flow problem (urgent plz)||jehanzeb||FLUENT||5||August 3, 2004 08:04|
|fluid flow fundas||ram||Main CFD Forum||5||June 17, 2000 21:31|
|Simulation of Two Phase Fluid Flow Problem Using Fluent 5.0||Mohammad Al-Shannag||Main CFD Forum||1||July 16, 1999 11:28|