CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Running, Solving & CFD (http://www.cfd-online.com/Forums/openfoam-solving/)
-   -   How to use boundaryFoam? (http://www.cfd-online.com/Forums/openfoam-solving/116186-how-use-boundaryfoam.html)

sharonyue April 15, 2013 03:05

How to use boundaryFoam?
 
Hi,

Just as boundaryFoam says:it can generate boundary layer conditions at an inlet for use.But how can I use this?I always dont know how to set the initial value of k and epsilon.Maybe this solver would help me out.

My thought is : generate a 1D mesh called inlet, and run boundaryfoam, then mapfield to my case.

But in the tutorial,the 1D mesh's height is only 5e-5m, but my case's inlet is about 0.5m,

How should I do? Thanks in advance.


All times are GMT -4. The time now is 01:47.