|April 15, 2013, 03:05||
How to use boundaryFoam?
Join Date: Jun 2012
Location: Torino, Italy
Posts: 710Rep Power: 8
Just as boundaryFoam says:it can generate boundary layer conditions at an inlet for use.But how can I use this?I always dont know how to set the initial value of k and epsilon.Maybe this solver would help me out.
My thought is : generate a 1D mesh called inlet, and run boundaryfoam, then mapfield to my case.
But in the tutorial,the 1D mesh's height is only 5e-5m, but my case's inlet is about 0.5m,
How should I do? Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|boundaryfoam||amit_100||Main CFD Forum||0||April 7, 2013 16:49|
|boundaryFoam, axisymmetry and turbulence models||thomas_toulorge||OpenFOAM Running, Solving & CFD||0||May 12, 2011 13:05|
|boundaryFoam vs. channelFoam||ang_dipl_ing_fd||OpenFOAM||0||March 29, 2011 14:51|
|1.6.x: Adaptive wall function: BoundaryFoam Tutorial||bastil||OpenFOAM Running, Solving & CFD||4||May 25, 2010 13:11|
|Problems with boundaryfoam||roberthino||OpenFOAM Running, Solving & CFD||0||March 13, 2008 11:13|