How to deal with a rotating shaft which is not in the rotating zone. -- CFD Online Discussion Forums

May 5, 2013, 20:00

How to deal with a rotating shaft which is not in the rotating zone.

sharonyue

Senior Member

Dongyue Li

Join Date: Jun 2012

Location: Beijing, China

Posts: 838

Rep Power: 17

Hi FOAMERS,

In this situation depicted in the image.the up impeller and the bottom impeller are in the rotating zone(I represent the rotating zone using two boxes).But the shaft actually is rotating.

How should I deal with this boundary condition without making the shaft embodied in the rotating zone?

Attached Images

1.jpg (24.0 KB, 4 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam)	Aadhavan	OpenFOAM Meshing & Mesh Conversion	2	March 8, 2018 01:47
[GAMBIT] periodic faces not matching	Aadhavan	ANSYS Meshing & Geometry	6	August 31, 2013 11:25
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 10:52
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
Problem in IMPORT of ICEM input file in FLUENT	csvirume	FLUENT	2	September 9, 2009 01:08

All times are GMT -4. The time now is 06:56.