|September 17, 2013, 21:07||
MRFSimpleFoam simulation flow over flat plate rorating
DANG QUOC BAO
Join Date: Apr 2013
Posts: 12Rep Power: 5
Thanks for your advice, I've carried out following your instructions and have good results.
Now I am doing some case studies using solver MRFSimpleFoam and SRFSimpleFoam to simulation flow over rotating flat. Parameter of flat includes length= 200 mm and width=20 mm with velocity inlet 10m/s. I used Turbulence property tools on website www.cfd-online.com for calculating initial boundary conditions of epsilon, k, omega...In case MRFSimpleFoam, I generated mesh model of flat which includes 3 zones fluid_inside (rotate), fluid_outside (stator), balde. However, both of the cases do not converge, bounding k and results of pressure and velocity very large. I dont know the reason why the errors appears.
I attached 2 cases (the following links) for MRFsimple and SRFSimple, could you have a look and help me identify where the problem is (due to initial boundary conditions, quality of mesh, fvchemes, fvsolution,...). I am confused but don't know where to find the answer for this problem.
Thanks for your help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Flat plate analysis in cfx||hamed.majeed||CFX||14||February 4, 2015 08:07|
|problem in Cf in flow over flat plate||mb.pejvak||Main CFD Forum||13||December 2, 2013 01:13|
|Simulations Flow 3D over Flat plate||baoaero||OpenFOAM||7||June 7, 2013 05:53|
|flow over an infinite flat plate||Vijay||CFX||0||April 7, 2008 05:01|
|Seperated Flow and Turbulence modelling flat plate||Simon Mizzi||Main CFD Forum||1||December 16, 2003 02:26|