|October 8, 2013, 17:52||
Thermal damBreak with interFoam not working...
Join Date: Jul 2012
Posts: 28Rep Power: 4
I am trying to do a dam break model with temperature using interFoam. I used the instructions found in www.tfd.chalmers.se/~hani/kurser/OS.../Project_QingmingLIU-final.pdf
with a few slight modification to allow compilation.
However, I get an error when trying to run the model:
|Thread||Thread Starter||Forum||Replies||Last Post|
|centOS 5.6 : paraFoam not working||yossi||OpenFOAM Installation||2||October 9, 2013 01:41|
|InterFoam stops after deltaT goes to 1e14||francesco_b||OpenFOAM Running, Solving & CFD||8||July 31, 2013 02:29|
|DPM parallel is not working but serial is working||johnwinter||FLUENT||1||March 27, 2012 02:01|
|Segmentation fault in interFoam run through openMPI||voingiappone||OpenFOAM||16||November 2, 2011 07:49|
|Info: Short Course On Thermal Design of Electronic Equipment||Arnold Free||Main CFD Forum||0||August 10, 1999 10:18|