|
[Sponsors] |
Thermal damBreak with interFoam not working... |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 8, 2013, 17:52 |
Thermal damBreak with interFoam not working...
|
#1 | |
Member
einat
Join Date: Jul 2012
Posts: 31
Rep Power: 13 |
Hello all
I am trying to do a dam break model with temperature using interFoam. I used the instructions found in www.tfd.chalmers.se/~hani/kurser/OS.../Project_QingmingLIU-final.pdf with a few slight modification to allow compilation. However, I get an error when trying to run the model: Quote:
Thanks!!! |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
InterFoam stops after deltaT goes to 1e14 | francesco_b | OpenFOAM Running, Solving & CFD | 9 | July 25, 2020 06:36 |
centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 01:41 |
DPM parallel is not working but serial is working | johnwinter | FLUENT | 1 | March 27, 2012 02:01 |
Segmentation fault in interFoam run through openMPI | voingiappone | OpenFOAM | 16 | November 2, 2011 06:49 |
Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |