|
[Sponsors] |
coupled boundary condition between two regions |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 19, 2013, 08:06 |
coupled boundary condition between two regions
|
#1 |
Member
|
Dear Foamers,
Is there any possible to use a thermally coupled boundary condition between two regions by swak (or groovybc) or something else? I have two solid and fluid regions where the following boundary condition should be satisfied. Code:
-Ks * grad(Ts) = h * (Tf - Ts) Best Regards, Hossein |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Phase change | PYJG | CFX | 10 | November 19, 2013 07:59 |
Velocity profile boundary condition | Tuca | FLOW-3D | 1 | April 23, 2013 12:02 |
No-slip condition for non-resolved boundary layer in open channel banks | Lupocci | Main CFD Forum | 1 | January 17, 2013 03:11 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |