|April 29, 2014, 14:33||
Creating volumes for analysis
Join Date: Mar 2014
Posts: 8Rep Power: 3
I'm attempting to simulate the flow of water through a tank using the interfoam solver. When setting up my CAD geometry I have been using a large block to represent the volume of air available to vent the tank.
I'm using a large open volume for the area which the water will be released to. Please see the image attached, the red is water, the blue is air.
My questions is, is there a BC i can use at the vents of the tank/ the exit of the tank which would allow me to avoid meshing these massive volumes?
|Thread||Thread Starter||Forum||Replies||Last Post|
|[GAMBIT] creating two volumes||Arvin||ANSYS Meshing & Geometry||1||January 20, 2014 10:28|
|Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam)||cfdonline2mohsen||OpenFOAM||3||October 21, 2013 09:28|
|[GAMBIT] problem with creating two seperate volumes||abhinavkolla89||ANSYS Meshing & Geometry||1||June 25, 2012 01:08|
|[GAMBIT] Creating Separate Mesh for touching volumes||damute||ANSYS Meshing & Geometry||9||February 25, 2012 15:32|
|Importing nodal data and creating volumes and mesh||milton||FLUENT||0||June 25, 2008 09:37|