Moving Mesh (dynamicMesh)

shantanukale · May 31, 2014, 02:22

Hello...
Kindly suggest some good suggested readings for dynamic mesh utility. I am simulating flow over cylinder and I want to oscillate the cylinder. I have found oscillating boundary condition, but that is the other way round. I want the cyilnder to be oscillating.

Thank You.

Kaskade · June 3, 2014, 05:05

I haven't used it yet, but I think you might need ACMI: http://openfoam.org/version2.3.0/ami.php

And have a look at the tutorial.

shantanukale · June 3, 2014, 06:47

Thank You.....
I am using OF 221. However, I could not find ACMI in my version. Any other alternative?

Thanks a lot in advance..

Kaskade · June 3, 2014, 06:54

That's because ACMI was added with 2.3. Just install it alongside 2.2.1. It doesn't replace your old installation.

May 31, 2014, 02:22	Moving Mesh (dynamicMesh)	#1
shantanukale New Member Shantanu Kale Join Date: Dec 2013 Posts: 25 Rep Power: 12	Hello... Kindly suggest some good suggested readings for dynamic mesh utility. I am simulating flow over cylinder and I want to oscillate the cylinder. I have found oscillating boundary condition, but that is the other way round. I want the cyilnder to be oscillating. Thank You.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
How to let the mesh motion solver just solve a small region near a moving boundary?	zhajingjing	OpenFOAM Running, Solving & CFD	9	April 28, 2016 04:15
snappyhexmesh remove blockmesh geometry	philipp1	OpenFOAM Running, Solving & CFD	2	December 12, 2014 10:58
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 19:43

June 3, 2014, 05:05		#2
Kaskade Senior Member Onno Join Date: Jan 2012 Location: Germany Posts: 120 Rep Power: 15	I haven't used it yet, but I think you might need ACMI: http://openfoam.org/version2.3.0/ami.php And have a look at the tutorial.

June 3, 2014, 06:47		#3
shantanukale New Member Shantanu Kale Join Date: Dec 2013 Posts: 25 Rep Power: 12	Thank You..... I am using OF 221. However, I could not find ACMI in my version. Any other alternative? Thanks a lot in advance..

June 3, 2014, 06:54		#4
Kaskade Senior Member Onno Join Date: Jan 2012 Location: Germany Posts: 120 Rep Power: 15	That's because ACMI was added with 2.3. Just install it alongside 2.2.1. It doesn't replace your old installation.