|February 16, 2015, 12:05||
Nonuniform inlet boundary condition
Join Date: Feb 2015
Posts: 10Rep Power: 2
I am totally new in OF. After I calculated the supersonic flow past a plate( the calculation domain is like an rectangular cavity). I want to extract the all the information at x=0.4m where the boundary thickness is the same as the experiment, including pressure, temperature, velocity, alpha, k, epsilon and mut which will be used as the inlet condition of my next step simulation.
I use paraView to extract all the information in table. But the value are listed on uniform distance. It would be difficult to copy all this information to the '0' folder by hand, because the grid is nonuniform in the y direction. Is there anything OF can do to simplify this procedure?
Last edited by JasonWang3; February 17, 2015 at 04:52.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to set up the inlet boundary condition for a low pressure case?||beastieboys6||FLUENT||3||April 10, 2012 22:46|
|Velocity inlet boundary condition for porous medium||Chander||CFX||3||March 11, 2012 22:18|
|External Radiation Boundary Condition (Two sided wall), Grid Interface||CFD XUE||FLUENT||0||July 8, 2010 06:49|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|nonuniform boundary condition( U=f(y) ) ?||panda60||OpenFOAM||2||November 5, 2009 13:28|