 |
 |
 |
|
|
|
[Sponsors] | ||||
April 25, 2015, 21:42
|
CompressibleInterFoam error
|
#1 |
|
New Member
chinmoy krushna mohapatra
Join Date: Apr 2015
Posts: 1
Rep Power: 0  |
Hi All,
I am trying to simulate both water and air flow in compressibleInterFoam. My case geometry is axsymmetric having cylindrical part followed by a nozzle and a orifice. My Input boundary condition has specific velocity values. for lower velocity combination my case runs fine but when I increased the both the phase velocity keeping the ratio same I encountered this error. Any help or suggestion is highly appreciated. error.docx Thank you Last edited by chinmoy; April 25, 2015 at 21:50. Reason: I dont want smileys |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
| [blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
| OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |
Linear Mode
