|
[Sponsors] |
January 20, 2016, 08:02 |
Sloshing simulation results mismatch OF2.3.1
|
#1 |
New Member
Join Date: Jul 2015
Posts: 12
Rep Power: 10 |
Hello,
I'm using OF2.3.1 for my M.Tech. project. I've done a horizontal harmonic excitation of tank similar to the studies carried out by Dongming Liu a, Pengzhi Lin in Journal of Computational Physics titled "A numerical study of three-dimensional liquid sloshing in tanks, 2008" for initial validation of solver, so that i can further use the same solver for my specific problem. The time history of surface height near left wall is attached in figure. The surface height computed by OF2.3.1 is almost 20% less than the results of Lin et. al. I've used interDyMFoam solver and used gen6DoF application for generating tank displacement. I varied the viscosity of liquid and checked but there is no variation in results. Could you please help me to find the reason for the mismatch in the results? Thanking you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Obtaining results from simulation | geod | FLUENT | 3 | February 27, 2015 09:44 |
Using the Results of Simulation | amingh | Structural Mechanics | 0 | February 25, 2014 04:25 |
Comparison of 2D simulation results with 3D | Mohit Gupta | Main CFD Forum | 0 | September 29, 2008 13:04 |
Gravity g's influence on Simulation Results | Colin | Main CFD Forum | 6 | November 2, 2003 14:13 |
graphical handling of simulation results | yf yap | Main CFD Forum | 3 | February 12, 2001 19:35 |