Problems using OpenFOAM through the simFlow GUI
1 Attachment(s)
Hello guys,
I'm Aldi, Newbie for OpenFoam. now i'm concerning to simulate of propeller case in OpenFoam. and i tried to use simFlow for processing that all. the simFlow that i used is 2.1 version, and when i was meshing the propeller, it was stopped because the node is over than 100000nodes, there was a comment from the window, that i have to buy and use simFlow without any limitations, so in my case, is it right? anybody can help me? because i need this solving, and i'm a student, and difficult for to buy the license, so that why i need some help from you all guys, thanks so much.:confused: Attachment 46946 |
error simFlow Running
1 Attachment(s)
here is my problem
Attachment 46976 |
Quick answers:
|
All times are GMT -4. The time now is 00:34. |