|April 24, 2016, 10:22||
Problems using OpenFOAM through the simFlow GUI
Join Date: Aug 2015
Location: Busan, South Korea
Posts: 23Rep Power: 3
Newbie for OpenFoam.
now i'm concerning to simulate of propeller case in OpenFoam.
and i tried to use simFlow for processing that all.
the simFlow that i used is 2.1 version,
and when i was meshing the propeller, it was stopped because the node is over than 100000nodes,
there was a comment from the window, that i have to buy and use simFlow without any limitations,
so in my case, is it right?
anybody can help me?
because i need this solving,
and i'm a student, and difficult for to buy the license, so that why i need some help from you all guys,
thanks so much.
Screenshot from 2016-04-24 23-11-09.jpg
|May 1, 2016, 17:06||
Join Date: Mar 2009
Location: Lisbon, Portugal
Blog Entries: 39Rep Power: 103
|Thread||Thread Starter||Forum||Replies||Last Post|
|Map of the OpenFOAM Forum - Understanding where to post your questions!||wyldckat||OpenFOAM||6||September 18, 2016 16:23|
|OpenFOAM and immersed boundary for cardiovascular problems||EmiS||OpenFOAM Running, Solving & CFD||0||February 11, 2016 11:38|
|Problems with OpenFOAM 1.7.1 on Ubuntu 14.10 (utopic unicorn)||alfa_8C||OpenFOAM Installation||2||February 3, 2015 04:16|
|Getting crazy with all the problems I have in OpenFoam||Nicacio||OpenFOAM Running, Solving & CFD||7||June 9, 2014 19:08|
|Salome -> OpenFoam ( Export as unv) Problems encountered||tibo11||OpenFOAM Native Meshers: blockMesh||8||January 9, 2013 07:39|