Dynamic mesh distortion

open · June 10, 2016, 04:00

This is a question I see has been posed previously without any resolution...

I have a simple 3D rectangular profile channel. The top face oscillates (pimpleDyMFoam, of 2.4) in the normal direction. It works fine in a 2D setup but in the 3D case distortion (severe non-orthogonality) results in divergence. Paraview shows that this is occurring close to the wall: since the wall is static the cells close by are effectively crushed as the top face oscillates inwards.

Wondered if anyone has experience/suggestions for correcting this?

As a first attempt I will try adding motion to the wall.

open · June 14, 2016, 07:04

So running with the extra dynamic BC on the walls (modified patches) does help; the case runs without crashing. There is a limit however to the amplitude to avoid cell crushing. The problem then requires use of layer removal for large amplitudes.

June 10, 2016, 04:00	Dynamic mesh distortion	#1
open New Member Join Date: Apr 2016 Posts: 13 Rep Power: 10	This is a question I see has been posed previously without any resolution... I have a simple 3D rectangular profile channel. The top face oscillates (pimpleDyMFoam, of 2.4) in the normal direction. It works fine in a 2D setup but in the 3D case distortion (severe non-orthogonality) results in divergence. Paraview shows that this is occurring close to the wall: since the wall is static the cells close by are effectively crushed as the top face oscillates inwards. Wondered if anyone has experience/suggestions for correcting this? As a first attempt I will try adding motion to the wall.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pls help. mesh collapsed with dynamic mesh.	wlt_1985	FLUENT	2	May 7, 2020 10:42
Dynamic mesh is not getting updated.	cardio	FLUENT	1	May 20, 2014 08:41
[ICEM] Dynamic mesh setup with ICEM	David121284	ANSYS Meshing & Geometry	0	April 11, 2014 04:19
Dynamic Mesh "Shadow Wall"	thezack	FLUENT	0	June 4, 2013 22:09
dynamic mesh for drop interface	IndrajitW	FLUENT	0	March 30, 2013 08:03

June 14, 2016, 07:04		#2
open New Member Join Date: Apr 2016 Posts: 13 Rep Power: 10	So running with the extra dynamic BC on the walls (modified patches) does help; the case runs without crashing. There is a limit however to the amplitude to avoid cell crushing. The problem then requires use of layer removal for large amplitudes.