|
[Sponsors] |
how to specify heat flux (convection coeff) on a wall boundary patch |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 14, 2016, 11:03 |
how to specify heat flux (convection coeff) on a wall boundary patch
|
#1 |
Senior Member
Pei-Ying Hsieh
Join Date: Mar 2009
Posts: 334
Rep Power: 18 |
Dear OpenFOAMers,
In OpenFOAM-2.3.x, there is a boundary type, externalWallHeatFluxTemperature the one can specify either heat flux or convection coefficient on a wall boundary patch. But, I cannot find one or similar in OpenFOAM-4.x. Can someone shed some light on how to specify wall heat flux/convection coeff on OF-4.x? Thanks! Pei-Ying |
|
July 14, 2016, 11:18 |
|
#2 |
Senior Member
Pei-Ying Hsieh
Join Date: Mar 2009
Posts: 334
Rep Power: 18 |
never mind! I found it.
Pei-Ying |
|
November 26, 2016, 15:47 |
|
#3 |
Senior Member
alberto
Join Date: Apr 2016
Location: Mexico
Posts: 117
Rep Power: 9 |
Hi can you tell me how i can put a heat flux in a wall?
i have a pipe full of air, and i want to give heat flux as Bc. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 08:30 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 18:44 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 7, 2008 00:17 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |