 |
 |
 |
|
|
|
[Sponsors] | ||||
November 4, 2014, 21:03
|
choose a directory to solve a DSMC case
|
#1 |
|
New Member
Li Wenchao
Join Date: Nov 2014
Posts: 1
Rep Power: 0  |
I found four subdirectories under the dsmcForm directory,
which is freeSpacePeriodic, freeSpaceStream, supersonicCorner, wedge15Ma5 respectively. I try to simulate a case that an aircraft reentry the atmosphere at the speed of Ma20. So which subdirectory under the dsmcFoam should I choose? Thanks! |
|
|
|
|
 |
| Tags |
| dsmc openfoam dsmcfoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| [DesignModeler] DesignModeler Scripting: How to get Full Command Access | ANT | ANSYS Meshing & Geometry | 53 | February 16, 2020 15:13 |
| [snappyHexMesh] jagged, ragged edges... | ziemowitzima | OpenFOAM Meshing & Mesh Conversion | 138 | July 23, 2012 23:41 |
| Error reading new case | montag dp | FLUENT | 5 | September 15, 2011 06:00 |
| OpenFoam install script Error during paraFoam installation | SePe | OpenFOAM Installation | 10 | June 19, 2010 15:15 |
Linear Mode
