|January 9, 2008, 05:50||
Hello, I am having a few pr
Join Date: Mar 2009
Posts: 42Rep Power: 8
I am having a few problems initializing my solution when using 'non-default' boundaries; i am using a turbulentIntensityKineticEnergyInlet and a custom boundary (profile for U). In all these boundaries, there is a 'value' keyword, this value is used to initialize the flow. How can i use the correct boundary conditions (i.e. the profiles) to patch?
One way would be to build a small application, but from what i have seen i do have to rewrite the profile parameters,... ideally i would just say, patch_using_boundaries() and U.write() and k.write().
I am generally using a variant of simpleFoam; but when using potentialFoam; i cannot get it to work properly because it doesnot pick up the 'complex boundaries' (not even this value keyword); and therefore U@inlet = 0, and nothing is solved.
So i am looking for a way to patch my U,k and epsilon files (get these internalField nonuniform List<vector>,...) from original files.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Boundary conditions for turbulent boundary layer||Thomas||FLUENT||1||June 17, 2008 05:14|
|boundary conditions for boundary layer flow||A. Al-zoubi||CFX||0||November 3, 2007 08:11|
|Slip Boundary Condition for Moving Boundary||Shukla||Main CFD Forum||3||November 11, 2005 16:02|
|pressure boundary VS. mass flow boundary||dalton||Main CFD Forum||12||April 3, 2005 23:52|
|Immersed boundary boundary treatment||AFP||Main CFD Forum||0||January 30, 2004 08:16|