[nico765]

Hello,

I have a small problem.
I compiled some of the komega turbulence models posted earlier on the forum. This worked fine.
I am now trying to switch back to the original models. So i compile OpenFOAM/OpenFOAM-1.3/src/turbulenceModels to get a new library OpenFOAM/OpenFOAM-1.3/lib/linuxAMD64Gcc4DPOpt/libincompressibleTurbulenceModels. so
But when i run a solver (turbFoam in my case), i get Valid turbulenceModel types are :

4
(
kOmega
laminar
kOmegaBSL
kOmegaSST
)

so something is still wrong. I must have missed a step somewhere.

Thanks

Nicolas

[panara]

you have to recompile the old turbulence models or use one of the option proposed in the other post..

Daniele

[nico765]

Yes, i think it's what i have done. As said above, i runned the allMake again in turbulenceModels, i got a new library (*.so). But i get the error. Does that mean that the library is still wrong, or is it something else?

Cheers,

Nicolas

[panara]

did you try first to wmake clean and than recompile?

Daniele

[nico765]

Yes i made sure of that.

I have deleted the OpenFOAM/OpenFOAM-1.3/src/turbulenceModels directory, copied again a clean one from the Gzip file. I still have the same problem.

If i understand well: a change in the turbulence models, will change the libincompressibleTurbulenceModels.so file, and therefore turbFoam. So i need to recompile both library and binary.

Do you know where this valid turbulence model check is done. I am sure that my libincompressibleTurbulenceModels.so file is correct.

Regards,

Nicolas

[hemph]

Hi Nicolas. Are you by any chance using the same name for your two different libraries? (incompressibleTurbulenceModels). If so, OpenFOAM will dynamically pick up the one under $(FOAM_USER_LIBBIN), as it is first in your $LD_LIBRARY_PATH. Have a look at the thread in http://www.cfd-online.com/cgi-bin/Op...cus/discus.cgi
where this issue is discussed.


//Rasmus

[nico765]

Ok, great. It works now. Thanks a lot, Rasmus.