 |
 |
 |
|
|
|
[Sponsors] | ||||
December 18, 2006, 23:00
|
Hi,everyone:
I've created
|
#1 |
|
Member
Bobby
Join Date: Mar 2009
Location: wuhan, hubei, China
Posts: 33
Rep Power: 17  |
Hi,everyone:
I've created a fluent mesh using ICEM, and set the boundary condition well. But, after I import the mesh into the FOAM, reset the boundary condition, start to caculate, it seems like there is something wrong with the boundary condition, because the fuel can not flow into the jet. I wonder if anyone can help me~~~! Thanks~! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Problem importing mesh in openfoam from fluent | alessandr0 | OpenFOAM Meshing & Mesh Conversion | 3 | September 4, 2008 13:41 |
| Importing mesh problem | ParodDav | CFX | 1 | May 14, 2007 18:15 |
| [Commercial meshers] A problem about Importing mesh from fluent | aderliner | OpenFOAM Meshing & Mesh Conversion | 1 | February 13, 2007 14:44 |
| A problem about Importing mesh from fluent | aderliner | OpenFOAM Running, Solving & CFD | 0 | December 18, 2006 23:05 |
| fluent mesh importing problem | Phil | FLUENT | 0 | February 19, 2002 03:44 |
Linear Mode
