 |
 |
 |
|
|
|
[Sponsors] | ||||
What does the variables R and nuTilda represent in the icofoam |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 16, 2005, 22:00
|
when i run the k-epsilone mode
|
#1 |
|
Senior Member
p ding
Join Date: Mar 2009
Posts: 427
Rep Power: 19    |
when i run the k-epsilone model in the icofoam, i found the "nutidilda" and R when i set the boundary condition.
what exactly does it represent. regards |
|
|
|
|
|
August 17, 2005, 04:28
|
You don't need then to run k-e
|
#2 |
|
Senior Member
Join Date: Mar 2009
Posts: 854
Rep Power: 22 |
You don't need then to run k-epsilon and this has already been discussed at length on this forum.
|
|
|
|
|
|
|
August 18, 2005, 22:21
|
where?
where?
|
#3 |
|
Senior Member
p ding
Join Date: Mar 2009
Posts: 427
Rep Power: 19 |
where?
where? |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Is it possible to have a mesh to represent a domain with a hole | kmurphy | OpenFOAM Meshing & Mesh Conversion | 3 | October 13, 2014 17:23 |
| SimpleFoam nutilda an R | linnemann | OpenFOAM Running, Solving & CFD | 13 | October 9, 2014 08:14 |
| Density in icoFoam Densidad en icoFoam | manuel | OpenFOAM Running, Solving & CFD | 8 | September 22, 2010 04:10 |
| How to represent two phase flow in Gambit | K.Baker | FLUENT | 4 | May 22, 2006 08:03 |
| [Gmsh] Is it possible to have a mesh to represent a domain with a hole | kmurphy | OpenFOAM Meshing & Mesh Conversion | 1 | May 3, 2006 04:45 |
Linear Mode
