 |
 |
 |
|
|
|
[Sponsors] | ||||
October 7, 2008, 00:26
|
Everyone:
I try to add C
|
#1 |
|
New Member
zhiwei liu
Join Date: Mar 2009
Posts: 22
Rep Power: 17  |
Everyone:
I try to add CrossWLF Model to simulate the injection molding process (polymers) .It does not work well . I still try to find these errors. But i hope to get someone's progam code and compared notes . Does anyone else use this Model? Could I share it ? my email is qinqinciwei-1@163.com Thanks! |
|
|
|
|
|
October 20, 2009, 21:59
|
|
#2 |
|
Member
Jitao Liu
Join Date: Mar 2009
Location: Jinan , China
Posts: 64
Rep Power: 17 |
Dear Zhiwei,
Is your CrossWLF viscosity model working well now? In order to simulate the polymer melt flowing process, I have added CrossWLF viscosity model and temperature equation to the interFoam solver. But the courant number increased enormously after a few steps.Then the calculation stopped. Please give me some tips. Thanks in advance. Kind regards, Jitao P.S. Would you mind sharing your code of CrossWLF model with me? My e-mail address is: liujitao@mail.sdu.edu.cn |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Radiation P1 Model with Spectral Model: Multigray | A. Thellmann | CFX | 0 | October 25, 2008 12:44 |
| Surface Reaction Model or Heterogeneous Rxn Model? | satheeskannan | FLUENT | 0 | September 2, 2008 18:55 |
| DPM model w/ Wave model - errors in documentation | HS | FLUENT | 0 | April 12, 2006 04:37 |
| Symmetry model half or total geometrical model in LES | vvqf | OpenFOAM Pre-Processing | 3 | March 22, 2006 09:06 |
| Copying boundary conditions from model to model | Lior | FLUENT | 3 | September 23, 2004 16:10 |
Linear Mode
