CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Running, Solving & CFD (http://www.cfd-online.com/Forums/openfoam-solving/)
-   -   GAMG does not work using the regionCouple-BC (http://www.cfd-online.com/Forums/openfoam-solving/71151-gamg-does-not-work-using-regioncouple-bc.html)

herbert December 17, 2009 05:50

GAMG does not work using the regionCouple-BC
 
Hi all,

I'm using OpenFOAM 1.5-dev in order to calculate conjugate heat transfer. This works fine, but when I want to solve the p-Equation in one region only using GAMG I get the following massage:

Unknown GAMGInterface type regionCouple.
Valid GAMGInterface types are :
4
(
cyclicGgi
ggi
cyclic
processor
)

When using any other solver (e.g. PCG) everything works fine.

Has someone a hint for me?

Regards
Herbert

herbert December 17, 2009 11:01

Me again,

I'm not sure if it was possible to change the boundaryType while the solver is running. This should solve the problem, but I don't know how to implement.


All times are GMT -4. The time now is 00:07.