|June 17, 2010, 06:03||
Air flow in a pipe
Join Date: Jun 2010
Posts: 6Rep Power: 7
I have a very simple 2D Case with 1 inlet and 6 outlets. but I think the results of the Simulation are far away from reality.
Here Are my files can someone help me?
and then klick "GMX Mediacenter starten"
At the inlet there are 1.7 bar. the outlets have ambient pressure.
The inlet Temperature should be 20°C oder 293.15K.
The velocity in an out streams are not known.
The Wall should be steel at ambient temperature of 293.15K
After the simulation I have over 400K in the pipe.
|Thread||Thread Starter||Forum||Replies||Last Post|
|setup problems - LES pipe flow with cyclic BC (1) and direct mapped inlet (2)||florian_krause||OpenFOAM||22||June 13, 2013 21:25|
|stepped pipe flow||Tom Cloutier||Main CFD Forum||0||April 20, 2003 13:19|
|Increasing air flow using fans||jim sanders||FLUENT||0||January 10, 2002 10:24|
|Hydrostatic pressure in 2-phase flow modeling (CFX4.2)||HB &DS||CFX||0||January 9, 2000 14:19|
|Hydrostatic pressure in 2-phase flow modeling (long)||DS & HB||Main CFD Forum||0||January 8, 2000 16:00|