|July 26, 2010, 10:22||
Question about gamma intgerpolation scheme
I have used recently the gamma interpolation scheme for convection terms, with some sucess I must say, in a flow problem where stress problems are relevant. However, in some cases the simulation crashes and I need to use other method.
I wonder if this a problem of the parameters I use in the method. In particular, in use gammaV 0.5 for the flow convective term and gamma 0.5 for other convective term but associated with extra stresses.
I know that lowering the parameter I should be getting more precision but less stability. But today I read in the forum some posts (This result reasonable help me) where the gamma method is used as gamma01 0.2 and gamma201 1.
Sincerely I am puzzled because I thought that gamma could not used with a constant larger than one, and I do not understand what means the numbers in front of th keyword.
Can someone tell me where I can get more information on the usage of gamma? A site with documentation wouls be great, only if the rules of capitalism did not interfere with that.
|Thread||Thread Starter||Forum||Replies||Last Post|
|AUSM scheme ? Central Scheme||boling||Main CFD Forum||5||September 9, 2009 19:06|
|Definition of limiter function for central dirrerencing scheme||sebastian_vogl||OpenFOAM Running, Solving & CFD||0||January 5, 2009 12:08|
|Fundamental problem with Gamma scheme||dominik_christ||OpenFOAM Running, Solving & CFD||3||August 29, 2008 08:24|
|Best Meshing scheme for Cylinder||Nutrex||Main CFD Forum||4||July 29, 2008 11:03|
|Scheme documentation and question||Mickaël Perrin||FLUENT||0||July 4, 2002 05:21|