How to setup a new problem from a grid generated in ICEM

Tarak · September 28, 2010, 16:45

Hii,

I'm new to OF, and would like to know how can I set up a new problem from a grid generated by ICEM. Presently I have been using meshes generated with blockmesh. So what should I do to supply the solver with my new grid, and also apply the neccessary BCs.

Thanks,
Tarak

akidess · September 29, 2010, 07:17

I'm not an expert, but I think the way to do it is export the ICEM mesh in FLUENT format and then use fluentMeshToFoam / fluent3DMeshToFoam to convert it to OpenFoam.

Tarak · September 29, 2010, 12:26

Hii,

Thanks for the reply. Actually what you mentioned is to be done for sure, but can you please let me know in which folder to place the meshfile to run the solver using it?

Thanks,
Tarak

September 28, 2010, 16:45	How to setup a new problem from a grid generated in ICEM	#1
Tarak Senior Member Tarak Join Date: Aug 2010 Location: State College, PA Posts: 111 Rep Power: 15	Hii, I'm new to OF, and would like to know how can I set up a new problem from a grid generated by ICEM. Presently I have been using meshes generated with blockmesh. So what should I do to supply the solver with my new grid, and also apply the neccessary BCs. Thanks, Tarak

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem with surface creation in ICEM from multiple curves	dialolema	ANSYS Meshing & Geometry	2	October 27, 2014 13:14
[ICEM] Meshing problem from ICEM CFD to Fluent	cfdonlinederafa	ANSYS Meshing & Geometry	2	September 21, 2010 16:16
ICEM HEXA Grid	Manish	Phoenics	0	March 12, 2005 05:07
Grid Independence problem for simple pipe geometry	chanchala	FLUENT	13	November 20, 2003 08:24
Combustion Convergence problems	Art Stretton	Phoenics	5	April 2, 2002 05:59

September 29, 2010, 07:17		#2
akidess Senior Member Anton Kidess Join Date: May 2009 Location: Germany Posts: 1,377 Rep Power: 29	I'm not an expert, but I think the way to do it is export the ICEM mesh in FLUENT format and then use fluentMeshToFoam / fluent3DMeshToFoam to convert it to OpenFoam.

September 29, 2010, 12:26		#3
Tarak Senior Member Tarak Join Date: Aug 2010 Location: State College, PA Posts: 111 Rep Power: 15	Hii, Thanks for the reply. Actually what you mentioned is to be done for sure, but can you please let me know in which folder to place the meshfile to run the solver using it? Thanks, Tarak