|September 10, 2010, 14:59||
Problem with pisoFoam
Join Date: Apr 2010
Posts: 122Rep Power: 8
I am trying to simulate the mixing of air and fuel jets in a combustion chamber. I have ran the inviscid incompressible case with icoFoam and pisoFoam. But i wanna use k-eps turbulence simulation. I have specified k eps BCs based on standard formulae. But as soon as switch on RAS model instead of laminar, the solution blows off. The Co number goes very high and crashes in 6-7 steps. I have tried every thing that i could think of. Changing timestep, fv schemes..nthing is helping.
Can some one have a look at my case files and give me any suggestion??? Its very argent...
Imagination is more important than knowledge..
Last edited by nileshjrane; September 10, 2010 at 15:37.
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF compiling problem||Wouter||Fluent UDF and Scheme Programming||6||June 6, 2012 04:43|
|Incoherent problem table in hollow-fiber spinning||Gianni||FLUENT||0||April 5, 2008 10:33|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|
|Is this problem well posed?||Thomas P. Abraham||Main CFD Forum||5||September 8, 1999 14:52|