 |
 |
 |
|
|
|
[Sponsors] | ||||
September 27, 2010, 11:32
|
interFoam hull with snappyHexMesh
|
#1 |
|
Senior Member
Emanuele
Join Date: Mar 2009
Posts: 110
Rep Power: 17  |
Hi, i made a mesh around a ship hull using snappyHexMesh. The "checkMesh" returns me a warning on 2 non-orthogonal faces (with checkMesh on 1.6 i had no warning). I started the simulation but it fails with a Floating point exception error. Have you any idea??
This is the case http://ubuntuone.com/p/E1i/ Regards Emanuele |
|
|
|
|
 |
| Tags |
| hull, interfoam, snappyhexmesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hydrostatic Pressure and Gravity | miliante | OpenFOAM Running, Solving & CFD | 132 | October 7, 2012 22:50 |
| [snappyHexMesh] Ship hull using snappyHexMesh | nuovodna | OpenFOAM Meshing & Mesh Conversion | 1 | June 28, 2011 10:45 |
| interFoam 1.6.x vs 1.5 : same mesh, same bc but different results | nuovodna | OpenFOAM Running, Solving & CFD | 9 | June 14, 2010 05:45 |
| [snappyHexMesh] stitchMesh and snappyHexMesh | gdbaldw | OpenFOAM Meshing & Mesh Conversion | 0 | December 23, 2009 02:09 |
| ControlDict for snappyHexMesh adn interFoam | erik023 | OpenFOAM Running, Solving & CFD | 3 | November 10, 2008 18:27 |
Linear Mode
