|November 4, 2010, 14:27||
Join Date: Oct 2010
Location: Leoben (Austria)
Blog Entries: 6Rep Power: 19
i made a case. There is a plate which is overflowed with water. (see pic). The background of the plate is cooled and had a fixed temperature. The fluid is hot and should cooling down while flowing above the plate.
If I start MultiRegionSimpleFoam its solving until 120 sec then the solving process is aborted. The temperature is leaving away. Too many iterations.
here is the case
i dont know what i did wrong. ):
and i am "new" at OF so i think i made a silly mistake.
Hope someone could help me.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Using Condor for batch queing with CFX||ellevset||CFX||2||January 15, 2014 12:10|
|interDyMFoam, problems in mesh motion solutor run in parallel||DLC||OpenFOAM||11||December 11, 2012 03:20|
|Getting too many iterations by velocity solving (aborting). Changing U - Solver?||suitup||OpenFOAM Running, Solving & CFD||0||January 20, 2010 08:45|