interFoam problem

chnrdu · March 20, 2011, 01:05

Dear all,

I'd like to simulate a nozzle jetting, I have tried the tutorial of dambreak. I use the dambreak as template to do the simulation, but it failed. The following is the two models: one is with nozzle, the other is without nozzle. and there's no input flow or pressure on the inlet boundary.

the problems are

1) the two models are the same, except the geometry. why the model w/o nozzle is successful when simulating, but the other one failed.

2) what means can improve it?

Thanks.

Best regards,
Martin

pbryant · March 20, 2011, 03:19

I don't know if this is your only problem, but if you run checkMesh you will find that both cases fail with "wedge patch front not planar"
-Paul-

chnrdu · March 20, 2011, 04:56

Thanks. I checked the mesh again. You are right. there's a point which is not on the front plane.
But the 1.6-ext checkMesh does not show me that infomation.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
interFoam (OF 1.7.1) in parallel ..need help	farhagim	OpenFOAM	4	July 26, 2012 16:42
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

March 20, 2011, 03:19		#2
pbryant New Member Paul Bryant Join Date: Feb 2011 Posts: 13 Rep Power: 15	I don't know if this is your only problem, but if you run checkMesh you will find that both cases fail with "wedge patch front not planar" -Paul-

March 20, 2011, 04:56		#3
chnrdu New Member Martin/Run DU Join Date: Mar 2009 Location: Hong Kong Posts: 25 Rep Power: 17	Thanks. I checked the mesh again. You are right. there's a point which is not on the front plane. But the 1.6-ext checkMesh does not show me that infomation.